How to install a light dimmer safely

How to install a light dimmer
credit image http://leisure.prior-it.co.uk

It is a good idea to install a dimmer light at your home for less energy consumption. It is not that difficult the way you perceive it to be. Adjusting a dimmer light in the bedroom or any other place at your home is very common as they provide a cool environment without interfering the amount of light that is preferred by everyone at night. Apart from it, there have many benefits of installing a light dimmer. They augment the beauty of your living space. Get these easy tips on how to install a light dimmer with minimum effort without calling a handyman.

Turning off power the first step of adjusting dimmer light

While going to adjust a dimmer switch, first turn off the main circuit box or temporarily fuse the box.

Turning off power the first step of adjusting dimmer light

credit image
http://www.cardosoelectrical.com

Make sure the power is cut off. For this, you can double check the switch. Use a normal tester to ensure that the wires inside the box are not charged as you remove the switch plate. Separate the old switch and plate. With the help of a screwdriver, take out the switch cover and remove it from the box.

Keep the wires separate from the existing switch

A screwdriver is a great necessity to perform these electrical tasks at the time of adjusting a dimmer light. With the help of it, you can loosen the electrical wires and detach them from the old switch. You should carefully check the color of the wires and see how they are attached to the structures as this will help you to perform the subsequent step of installing a dimmer switch. After taking the wires out, bend them and keep in the corner of the box. Tools like needle nose pliers will be of great help while working in small spaces to adjust the dimmer switch.

Keep the wires separate from the existing switch

credit image
https://www.tubesandmore.com

Place the dimmer switch

You should have some basic knowledge about the three main wire colors while adjusting the dimmer light. One is black, the other one is white and a ground wire that is found mostly wrapped in a green color.

Place the dimmer switch

image credit
http://buildingmodern.net

Now you attach the wires the same way those were attached to the old switch. Fix them up properly with help of a screw so that they may not have any scope of coming out. In case of smaller wires by using a plier, you can gently fold them up into one whole unit.

Adjust the dimmer switch to the box and attach the switch plate in its original position

After folding all the excess wires, now you should place the dimmer switch into the electrical box. Take extra care with the wires to make sure they do not get a break or come out and if necessary put some pressure to adjust them to their position. Tightening the dimmer switch screws make them well fitted into their position.

Tightening the dimmer switch screws

image credit
http://canadiantire.scene7.com

Thereafter you turn the switch on to enjoy the dimmer light.

The necessary safety precaution to be taken while adjusting a dimmer light

Not all the bulbs are meant to be used with dimmer switches, you must check twice before installing them. A wrong installation can cause damage to the bulb and the whole dimmer switch electronics. Check the bulb’s packaging content carefully as you will see all the safety instructions given there. Just check if they can support the dimmer light.

Reading this information on how to install a light dimmer will help you to try it out at home. It will reduce your dependency on a professional in many occasions. Get this wonderful product which can help you to control your light dimmer-

Update Blackt Electrotech

However whenever you need better guidance and professional help to install a light dimmer, then contact Mr right services. We are always there to assist you!!

You might also like

One comment

  1. 1

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>