Freon – the technical name of the gas refrigerant in the AC – with time gets depleted and needs to be replenished in order for the AC to continue cooling. Hire the best Pros for the job now!
|Duration||30 mins - 1 hour|
|Turnaround Time||2 hours|
|Pricing||Depends on gas type and quantity|
Great service by Ankit Kumar. He is well versed with AC technicalities and is extremely humble and down to earth human being. He is a good asset to your company. Kudos to you.
Excellent service person Mr sunil kashyap..but they are charging above as mentioned.. After complaint company agreed and I have paid listed amount
Hi, I have made Rs 3600 for 2 ac, not Rs 1200 as mentioned in message to me, however, the service was very good.
Good skilled resource. Took time to explain the details and did the job diligently. Would definitely recommend.
Expert and knew the job very well. Very polite and humble. Ac Gas refulling Work done to my satisfaction.
Skilled/honest individual with the latter being a huge quality in today's times,recommend highly.
I am very much pleased with the AC service provided by Mr. Dharmender Parshad
Very good service. They went ahead and serviced/ cleaned the AC too.
Service was good and in professional manner.
Excellent work.very professional ...
Lack of coolant (Freon) is a very common reason behind AC not cooling problem. The coolant circulates through the evaporator coils and cools the air flowing over it and eventually sends cool air into the room. So when the level of this coolant becomes insufficient, the AC fails to cool. In many cases the coolant leaks from the unit and AC stops cooling. An AC repair professional will be able to accurately determine if the refrigerant level is just right in the cooling coils.
The PRO accurately determine the coolant level in the AC unit using a pressure gauge. If the level of gas, also called refrigerant is found below the normal PRO suggests a refill or top-up as per requirement.
To start the coolant recharge, first the AC unit is shut down. Thereafter the gauge hoses are attached to the pressure port of AC unit. The AC unit is then turned on and allowed to run for 10 min so that it can reach a stable state of operation. Following it the valves of the refrigerant container (with container in the upright position) is connected to the AC unit. Now the AC unit is ready to draw coolant.