7 important guidelines for split AC installation

Window AC uninstall

The installation of the split air conditioners is a crucial job. If the installation is done accurately your air conditioner will give optimum cooling, but if it is not done properly you won’t get the desired cooling effect. A poor installations also leads to frequent maintenance problems.

Several factors have to considered during the installation of split air conditioner.

1. Strength of wall to hold the AC

The indoor unit of split AC must be installed on a wall strong enough to hold the unit’s weight.

2. Proper spacing between wall and AC unit

The indoor unit of split AC requires at least 15 cm of open space surrounding its top and sides for proper air flow.

3. Appropriate installation height from ground

Mount the indoor unit of split AC at a height of 7-8 feet above the ground for adequate cooling inside the room

4. Correct tilt angle of indoor unit

While fixing the aluminum bracket on wall make sure that the bracket is given a slight tilt angle, so that the indoor unit of split AC, when fitted is also at a slight angle to enable unrestricted flow of the condensed water from the drain pipe.

5. Correct location of outdoor unit

For proper cooling, mount the indoor and outdoor units of split AC at location away from direct sunlight and water. Install the outdoor unit of split AC in open space so that there is no hindrance to the heat dissipated from the condenser.

6. Proper placement of outdoor unit

The outdoor unit of split AC must be placed on a flat and rigid surface. This unit contains key components of split AC like compressor, condenser, fan motor etc. If the unit is not on a flat surface then it will vibrate excessively, which can lead to the breakage of copper pipes, coolant leakage and compressor/condenser damage. Further, the vibrating unit makes lots of noise which could disturb you and your neighbors.

Recommended Out Door Unit Stands available online:-

Our Pick

7. Right distance between indoor and outdoor unit 

Correct distance between the indoor and outdoor unit plays a very important role in cooling. The coolant at very low temperature flows inside the copper tubes between indoor and outdoor units of split AC. There is always some loss of cooling effect to the atmosphere when the refrigerant flows between the units. Hence to reduce this loss, keep the distance between the indoor unit of split AC and the outdoor unit of split AC as minimum as possible. The maximum allowable distance between the indoor and the outdoor units of split AC can be about 15 meters.

Our Pick

A good quality Copper Pipes are always recommended for AC Installation. Here, we have some recommendations for you:-

Our Pick

We also recommend these other AC Covers to keep your AC dust free when not in use:-

You might also like


  1. 1

    Clean and change filters regularly for efficient system operation and to prevent dust, dirt, and mold buildup. Check for leaks or blockages to avoid damage. Get an annual inspection from an HVAC technician to identify and address potential issues early.super general ac

  2. 2

    En kaliteli canli Mobil Sohbet Sitemiz Ile yuzlerce kisilerle tanisip dost arkadas edinip harika sesli sohbet ortamlarinda bulunabilirsiniz. Simdi den en guzel harika Mobil chat ortamlarinda sizleri bekliyor iyi sohbetler bol eglenceler dileriz sitemizi ziyarat edip chat odalarimizda bulunup sizlerde eglencenin adina varabilirsiniz iyi sohbet diliyorum herkese..

  3. 3
  4. 4
  5. 5
  6. 6
  7. 7
  8. 8
  9. 10
  10. 11
  11. 12
  12. 13

    A split type AC should be put at 7 -8 feet in a 10 foot height room for the maximum cooling performance .online class help The optimal height for a window type AC is 3-4 feet from the floor. If you install the AC very close to the wall or in an airtight space, it will trip owing to high head pressure because heat dissipation is impossible.

  13. 14

    Safety Nets have become a must now in every building. It is used in apartments and in the office area. Mostly you can see safety nets in a high-rise buildings and it will ensure safety for all kinds of purposes. Choose Balcony Safety Nets Chennai

  14. 15
  15. 16

    When it comes to cooling, the distance between the interior and outdoor units is crucial. The coolant flows between the interior and outdoor split AC units through copper tubes at a relatively low temperature. Thank you!

  16. 17
  17. 18
  18. 19
  19. 20
  20. 21

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>